Table of Contents
Advertisement
Ice Maker Replacement - continued.
3. As you slide the ice maker onto the shoulder screws,
you cannot see the two rear screws. Therefore, after
installing the ice maker, you must pull down on the two
back corners to be sure it is attached to the two rear
screws. If not, then pull the ice maker off the screws
and repeat the previous step.
4. Connect the two harnesses at the front of the Ice
Maker Housing.
5. Install the Harness Cover so that the two tabs on the
back of the Cover are inserted over the top of the ice
maker frame.
6. Tuck the harnesses into the cover as shown. Be sure
that the harness coming from the ice maker and the
Air Handler are inside the notch in the Harness Cover.
Figure 6-73.
Note: Use care to make sure that all the wires are com-
pletely inside the cover so they do not get pinched.
7. Push the Cover into position and drive in the screw.
The extended lip on the front of the cover is to be in-
serted into the slot on the top of the ice maker housing.
Figure 6-74.
8. To install the Ice Maker Housing Front Cover, slip the
tab on the back of the cover underneath the correspond-
ing tab on the Ice Maker Housing. Figure 6-75.
9. Install the two screws that hold the Front Cover to
the Housing.
10. Reinsert the Ice Bucket into the Ice Maker Housing.
Component Teardown
align and drive screw
corresponding tabs
6-25
proper routing of the harness in
the channel and under the tab
Figure 6-73
Figure 6-74
Figure 6-75
Hide quick links:
Advertisement
Table of Contents
