Frigidaire LGUB2642LF2 Service Manual page 113

Freezer Upper Basket Removal
1. Remove all items from baskets.
2. Remove basket by pulling basket out to the full
extension and lift out.
To reinstall upper baskets:
Position basket onto the retainer clips making sure the
front of the basket rests in the retainer clips on the
stabilizer bar.
If the upper basket is installed with the tabs towards the
front of the unit, the upper basket will "kick out" when
the drawer is opened. (See Figure 6-20)
If the upper basket is installed with the tabs towards
the rear of the unit (backwards), the upper basket will
remain inside the freezer when the drawer is opened.
NOTE: If basket is not resting on stabilizer bar retainer
clips, the drawer will not close properly.
Freezer Lower Basket Removal
1. Remove all items from basket.
2. Remove the basket by tilting it forward and lifting
it from the retainer clips. (See Figure 6-21)
3. To reinstall lower basket, insert basket into retainer
clips.
Freezer Drawer
1. Open freezer drawer.
2. Remove drawer screws on right and left sides two
(2) screws on each side. (See Figure 6-22)
3. When reinstalling, snug drawer screws then turn
another 1/4 turn.
DO NOT remove center screw from freezer drawer.
This is a factory adjustment.
3. Close freezer drawer. The freezer drawer must
mount parallel to the cabinet face. Measure the
distance from the top and bottom of drawer to the
cabinet face, adjust drawer screws until distance
is equal. Check gasket seal around freezer drawer.
Make adjustments on drawer screws if necessary.
Door and Drawer Gasket Removal
The door and drawer gaskets are removed by pulling
the gasket from the channel molded in the unit door or
drawer frame. (See Figure 6-23)
Component Teardown
Retainer
6-7
Freezer Top
Basket
Figure 6-20.
Basket
Figure 6-21.
Figure 6-22.
Figure 6-23.
Drawer
Screw
Drawer
Screw