Ford F-150 2002 Workshop Manual page 9

2002 F-150 Workshop Manual
5. NOTE: To prevent any squeaks or rattles, install and tighten the upper instrument panel floor brace bolt first, then tighten the floor brace bolts and nut.
NOTE: Reposition the carpet after this step is carried out.
Install the instrument panel floor brace.
1. Install the upper instrument panel floor brace bolt.
2. Tighten the instrument panel floor brace bolts and nut.
6. Install the instrument panel reinforcement bolt below the LH corner of the glove compartment.
7. Install the instrument panel bolt on the relay bracket.
8. Install the instrument panel bolts through the passenger side air bag module opening.
Install the RH bolt first.
9. Install the antenna lead-in cable into the instrument panel.
1. Position the antenna lead-in cable into the instrument panel.
2. Connect the cable locators between the instrument panel channel and the audio unit end of the cable.
10. Install the audio unit. For additional information, refer to
11. If equipped, connect the EATC hose to the evaporator case.
http://www.fordtechservice.dealerconnection.com/pubs/content/~WS21/~MUS~LEN/19/S...
Section 415-01.
Page 9 of 16
2/18/2010