Rheem 27 874 Series Owner's Manual And Installation Instructions page 34

TEMPERATURE CONTROL – DELUXE
7. Open the hot tap.
The operating light will glow on all Deluxe controllers.
Measurement of the water flow at the water heater will
commence when the hot tap is opened.
Notes:
If a second hot tap is opened when the Bath Fill mode
is turned on, the set bath fill water volume expected
from the first hot tap will be reduced by the volume
which flows through the second hot tap.
The bath fill temperature setting and bath fill water
volume setting can also be adjusted whilst a hot tap is
open and the Bath Fill mode is operating.
When the set volume of water has passed through the
water heater:
Water flow from the hot tap will cease.
The operating light will go out.
The bath fill water volume display panel will show
0 litres.
The temperature display will go blank.
The BATH FILL operating light will commence to flash
The voice prompt will sound;
"the bath is ready, please turn off the hot water tap
and press the BATH FILL button to finish"
8. Close the hot tap.
Turn off the Bath Fill mode
9.
Press the BATH FILL button.
The BATH FILL operating light and bath fill indicator
light will go out.
The bath fill water volume display will go blank.
Note: If the hot tap has not been turned off, the
voice prompt will sound;
"please ensure the bath hot water tap is turned off"
34
ACTIVE
1 2 0 4 0 °C
BATH (l)
BATH FILL
ACTIVE
4 0
0 °C
BATH (l)
BATH FILL
"the bath is ready,
please turn off the hot water tap
and press the
BATH FILL button to finish"
ACTIVE
4 0
0 °C
BATH (l)
BATH FILL
ACTIVE
0 4 0 °C
BATH (l)
BATH FILL
"please ensure the bath hot
water tap is turned off"
ON/OFF
ON/OFF
ON/OFF
ON/OFF