Initial Setup Instruction Guide - Akai 42” Operating Insructions

 Connect to antenna
ATSC (DTV) & NTSC(ATV) input connection config
1. There are two Antennas:
- ANT 1 is only for ATSC channel of Air or Clear QAM.
- ANT 2 is only for Air or Cable Signal of NTSC.
2. The user can select the Antenna input as below:
A. One Antenna is for signal config.
B. Two Antenna config A
ANT 1 is only for ATSC channel of Air or Clear QAM.
ANT 2 is only for signal of NTSC.
ATSC/
Clear QAM
NTSC

Initial Setup Instruction Guide

Connect the power and antenna to your television; then turn on TV . The first time
you use your LCD the initial setup menu will appear on the screen:
Move the cursor as follows:
Press or
"Language", and then press
to select "English", "Français" or
"Español".
Press or
"Tuner Mode", and then press
to select " Cable" or "Air".
Press or
Note: Initial setup is for the Analog TV stations only.
If you would like to end the scanning process, press Enter button to exit. If you
would like to scan for stations again, select "Searching" in the TV menu.
If you select "Cancel" and do not scan in the TV menu, the initial setup menu
will appear again when you turn on TV next time.
18
Splitter
to highlight the item
or
to highlight the item
or
to select "OK" to start scan, or "Cancel" to exit.
ANT 1 (DTV)
ANT 2 (ATV)
ANT 1 (DTV)
ANT 2 (ATV)