Rear View - Akai 42” Operating Insructions

4.3 Rear View

Wall Mount holes (four holes): Use the provided screws (M5) to affix the wall
mount.
Power Inlet: Use the power cord included and connect to an earthed 120V,
60Hz AC outlet.
Signal input and other terminals:
. ANT1 & ANT2: 75Ω Coaxial connector for Antenna/Cable Network.
Note: ANT 1 is for ATSC(DTV), and ANT 2 is for NTSC(ATV). (Refer to page 18.)
. OPTICAL OUTPUT: Connect the optical output to the optical input connector
of the Amplifier. (Only for DTV)
. RS-232: The D-SUB 9 Pins terminal is used as a control port for serial
communication between PC and Panel. (Only for after-sales service & DTV)
. HDMI 1 INPUT: For high quality picture display purpose. Connects to HDMI or
DVI (with DVI to HDMI Adaptor- not provided) digital output connector of the
DVD or HDMI Set-top box.
. HDMI 2 INPUT: For high quality picture display purpose. Connects to HDMI or
DVI (with DVI to HDMI Adaptor- not provided) digital output connector of the
DVD or HDMI Set-top box.
. VGA/DVI AUDIO INPUT: Connect the audio input terminal to the audio output
terminal of DVD or HDTV Set-top box with VGA/DVI output terminal.
Note: The DVI/HDMI audio input is only compatible for one of the three inputs: HDMI1,
HDMI2, or VGA. If your HDMI connection passes audio then you will not need the
Audio Input for that device.
. D-Sub (VGA) INPUT: For PC display purposes. Connects to the Mini D-Sub
15 Pins analog output connector of the PC display card.
. YPbPr (COMP2) INPUT: Connect the Component video input terminal to the
Component terminal of the video output device.
YPbPr (COMP2) Audio INPUT: Connect the audio input termianl to the audio
output terminal of the video output device.
Diagram
11