Remote Control - Trane MCC 518 ZB Owner's Manual

Indicators on Infrared

Remote Control

System Operating Selection
FAN Only System Operation
- Press POWER button (the display
panel shows the previous settings).
- Press MODE button to select the
system operating mode, FAN mode
will be shown on the display.
- Press FAN button to select any fan
speed. The FAN display will show
LOW, MED, HIGH or AUTO
according to fan speed level, low,
medium, high and auto.
COOLING System Operation
- Press POWER button (the display
panel shows the previous settings).
- Press MODE button to select the
COOL operating mode, "COOL"
mode will be shown on the display.
- Press either TEMP or TEMP
button to set the desired room
temperature. Temperature set
O O
range is 18 C to 30 C.
- Press FAN button to select any fan
speed. The FAN display will show
LOW, MED, HIGH or AUTO
according to fan speed level, low,
medium, high and auto.
6
DRY System Operation
- Press POWER button (the display
panel shows the previous settings).
- Press MODE button to select the
DRY operating mode, "DRY" mode
will be shown on the display.
- Press either TEMP or TEMP
button to get the desired room
temperature setting at the
indication. Temperature set range
is 18 O C to 30 O C.
- The system automatically cycle the
compressor and fan (low speed) to
remove moisture from the air
without overcooling the room.
Timer Operation
Once you select the timer operation,
the settings are saved in the remote
control. Thereafter, the air
conditioner will start operating under
the same conditions when you simply
push the POWER button of the remote
control.
Setting STOP Timer
You can set the STOP timer to stop
the unit automatically at any desired
time up to 24 hour ahead.
Setting Auto-Stop Timer
You can set the stop timer to stop....
- During the operation of the
air-conditioner, press the TIMER
button and the air conditioner will
enable stop timer to automaticall
turn off the unit
- Press the HOUR button to set the
time you want to turn off the unit.
Every time the button is pressed,
hour indicator will be increased by
1 hour
- After the time is set, the digits shown
on the display screen will go
down by 1 for every elapsed hour
- Press the TIMER button again to
cancel timer
Setting START Timer
You can set the START timer to start
the unit automatically at any desired
time up to 24 hour ahead.
MCC-SVU02A-EN