Operating Instructions; Setting Water Temperature; Activate Pumps; Standard Light Operation - Sundance Spas Hawthorne Owenrs Manual

9.0 Operating Instructions

The spa control system has automatic functions that operate upon start-up
and normal operation to protect the system. Upon power up, the readout
displays the following information:
1. Control panel displays current software
release (3.56 or 5.55 depending on spa
model) then;
2. Control panel displays "888" and all indica-
tor LEDs are lit, permitting visual inspection
of all display segments and indicator lights
for proper operation.
3. After the initial start-up sequence ends, the
actual water temperature is displayed. If
water temperature at this time is less then
the factory default temperature setting of 100°F (38°C) and the spa is set
to either standard filtration/heating mode (Sections 10.1-10.2, page 22),
the heater will turn on and run until the water temperature rises to the fac-
tory setting, then turn off. Note: it is common for the heater to turn on after
the spa is first filled because tap water is often very cold.

9.1 Setting Water Temperature

The spa's thermostat provides optimum control of water
temperature. The temperature set point (set temperature) can
be adjusted from 65-104°F (18-40°C). To raise the set tempera-
ture, press the WARMER (+) button. To lower the set tempera-
ture, press the COOLER (-) button. Note: The first press of either WARMER
(+) or COOLER (-) button displays the set temperature.

9.2 Activate Pumps

The control panel JETS 1 button activates jets pump 1. The
first press activates low speed, the second press activates
high speed, and the third press shuts jets pump 1 off.
The JETS 2 button activates jets pump 2. The first press
activates high speed, the second press turns jets pump 2
off. When manuallly activated, either pump will automatically turn off after 20
minutes.

9.3 Standard Light Operation

The light button activates the footwell light in the spa when pressed.
Pressing the button turns the footwell light off. When manuallly acti-
vated, the footwell light will automatically turn off after one hour.
Spas with Spas with Spas without Spas without
Circulation Circulation Circulation Circulation
Pump Option Pump Option Pump Option Pump Option
1. 1.
2. 2.
3. 3.
Page 19