Adapter Configuration Utility - Lenovo 8200 Series Installation Manual

QLflash Options
QLflash.exe <1...N | ALL> [options]
/SLT
SLT: Sets the application to silent mode
Use application return code for success or failure
/SIL=filename.ext
SIL: Load multiflash image from file
/PRV | /VPP | /PRN
PRV: Print firmware versions
VPP: Print VPD contents
PRN: Print MAC addresses and worldwide port name (WWPN)
/CFU=filename.ext | /CFS=filename.ext | /CFC=filename.ext
CFU: Flash board configuration from file
CFS: Save board configuration file (need template file BRDCFG.DAT)
CFC: Compare board configuration to a binary file
/NVU=filename.ext | /NVS=filename.ext | /NVC=filename.ext
NVU: Flash NVRAM from file
NVS: Save NVRAM to file (need template file NVRAM.DAT)
NVC: Compare Flash to NVRAM file
/UIL=filename.ext | /UIS=filename.ext | /UIC=filename.ext
UIL: Flash user information data from file
UIS: Save user information data to file
UIC: Compare user information data to a binary file
• If you used an FC RAID target in a cluster environment, you should enable the
Note:
Enable Target Reset = Enabled (Advanced Adapter Settings).
• Use the /I option if the update utility, QLflash, does not detect your adapter.
• QLogic recommends disabling the internal disk before installing the OS or
booting to the FCoE disk.

Adapter Configuration Utility

Note: The CNA Function Configuration utility does not run on SUN™ SPARC
This section provides detailed configuration information for advanced users who want to customize the
configuration of the 8200 and 3200 Series Adapters and the connected devices. You can configure the
adapters using the CNA Function Configuration utility.
8200 Series Converged Network Adapter and 3200 Series Intelligent Ethernet Adapter
®
systems.
6
Page