Selective Call; Ctcss And Dcs - Kenwood TH-F6A Instruction Manual

SELECTIVE CALL

CTCSS and DCS

You may sometimes want to hear calls from only
specific persons or groups. In this case, use the
selective call function. This transceiver is equipped
with CTCSS (Continuous Tone Coded Squelch
System) and DCS (Digital Coded Squelch). These
selective calls allow you to ignore (not hear)
unwanted calls from other persons who are using the
same frequency. The transceiver unmutes only when
it receives the signal having the same CTCSS tone or
DCS code.
Note:
CTCSS and DCS do not cause your conversation to be private or
scrambled. It only relieves you from listening to unwanted
conversations.
CTCSS and DCS function in only FM mode.
ST STA CON CON PACKET96 96BCONDUP
7 9
5
28
CTCSS (Continuous Tone Coded Squelch
System)
A CTCSS tone is a sub-audible tone and is selectable
from among the 42 tone frequencies listed in the
table on the following page. The list includes 37 EIA
standard tones and 5 non-standard tones. You can
select one of the tones to use as a CTCSS tone.
USING CTCSS
1 Press [TONE] until "CT" appears.
•
ST STA CON CON PACKET96 96BCONDUP
9
7
5
When the CTCSS funtion is ON, you will hear calls
only when the selected CTCSS tone is received. To
answer the call, press and hold the PTT switch, then
speak into the microphone.
ST STA CON CON PACKET96 96BCONDUP Note:
9
7
5
You cannot use the CTCSS and Tone/ DCS functions
simultaneously. Switching the CTCSS function ON after having
activated the Tone/ DCS functions deactivates the Tone/ DCS
functions.
If you select a high CTCSS frequency, receiving audio or noise
that contains the same frequency portions may cause CTCSS to
function incorrectly. To prevent noise from causing this problem,
ST STA CON CON PACKET96 96BCONDUP
select an appropriate squelch level {page x}.
7 9
5
SELECTING A CTCSS FREQUENCY
1 While in CTCSS mode {above}, press [F],
[TONE].
•
2 Turn the Tuning control or press [ ]/ [ ] to select
your desired CTCSS frequency.
•
3 Press [s s s s s ] or [MNU] to store the new setting.
Otherwise, press [t t t t t ] or [PTT] to cancel.
Each time you press [TONE], the icon cycles
as follows: "T" (TONE)
"DCS" (DCS) " " (OFF)
The current CTCSS frequency appears.
The selectable CTCSS frequencies are the
same as those for the Tone frequency. Refer to
the table on the following page for the available
CTCSS frequencies.
"CT" (CTCSS)
"T" (TONE).