Table of Contents
Advertisement
SUCTION HOSE
INLET VALVE
MOTOR
POWER SUPPLY CORD
ON/OFF SWITCH
SPRING GUARD MUST BE
AT ROLLER VALVE INLET
USE TWO WRENCHES
TO TIGHTEN
SPRAY VALVE
USE TWO WRENCHES
Fig 1
1. Remove all parts from the boxes and assemble them
as shown in Fig 1, following the notes on the drawing.
2. Prepare the material according to the manufactur-
er's recommendations. Remove any skin that may
have formed on the top of the material. If necessary,
thin the material.
WARNING
Never remove the third (grounding) pin of the power
supply cord. Be sure the outlet is properly grounded.
In the event of an electrical short circuit, grounding
reduces the risk of an electric shock by providing an
escape wire for the electric current.
Inspect the power supply cord and extension cord
before each use. Be sure they are in good condition
and have undamaged three-pin plugs. Replace im-
mediately if either cord shows signs of wear or
damage.
SETUP
PRIMING TUBE
TRIGGER
TO TIGHTEN
PRIMING VALVE
FILTER
USE TWO WRENCHES
TO TIGHTEN
3. Plug the power supply cord into a properly grounded,
120 V electrical outlet. See Fig 2. Do not use an
adapter. All extension cords must have three wires.
Use the chart below for selecting the appropriate
wire gauge for the extension cord.
Cord Length
feet
(meters)
1–100
(1–30)
100–200
(30–61)
200–300
(61–92)
over 300
(over 92)
GROUNDED
OUTLET
GROUNDING PIN
Fig 2
25 FT. (7.6 M) HOSES
Extension
Wire Gauge
18
16
14
12
Advertisement
Table of Contents
