HYOSUNG Comet650 Owner's Manual page 55

★ ★ BREAKING IN THE NEW TIRES
New tires need proper break-in to assure
maximum p e r f o r m a n c e , just as the
engine does.
Wear in the tread surface by gradually
increasing your cornering lean angles
over the first 160km(100miles) before
attempting maximum performance. Avoid
hard acceleration, hard cornering, and hard
braking for the first 160km(100miles).
WARNING
Failure to perform break-in of the tires
could cause tire slip and loss of control.
Use extra care when riding on new tire.
Perform proper break-in of the tire as
described in this section and avoid hard
acceleration, hard cornering, and hard
braking for the first 160km(100miles).
★ ★ ALLOW THE ENGINE OIL TO CIR-
CULATE BEFORE RIDING
Allow sufficient idling time after warm or
cold engine start up before applying load
or revving the engine. This allows time
for the lubricating oil to reach all critical
engine components.
★ ★ OBSERVE YOUR FIRST, AND
MOST 1,000km SERVICE
The 1,000km (600miles) service is the
most important service your motorcycle
will receive.
During break-in procedures, all of the
engine components will have worn in
and all of the other parts will have seated
in.
All adjustments will be restored, all fas-
teners will be tightened, and the dirty
engine oil and engine oil filter will be
replaced.
Timely performance of the 1,000km
(600miles) service will ensure optimum
service life and performance from the
engine.
Service should may be peformed before
1,000km(600miles) on motorcycle that
are used under severe conditions.
The 1,000km (600miles) service should
be performed as outlined in the
INSPECTION AND MAINTENANCE sec-
tion of this Owner' ' s Manual. Pay partic-
ular attention to the 『 『 CAUTION』 』 and
『 『 WARNING』 』 in that section.
55
CAUTION
CAUTION