Removing The Washer Door And Door Switch - Kenmore 110.42822200 User Manual

There are nine tabs securing the Touch Pad/LED
Assembly to the console. (Fig. 3-9)A flat bladed
screwdriver will be helpful in releasing these tabs.
Typical Release Tab
Fig.3-8
R E M O V I N G T H E W A S H E R
The washer door can be removed by removing
the two screws securing the door hinge to the
washer front and lifting upward.
F ig .3 -1 0
Access to the door switch requires that the water
seal boot be removed from the front of the washer.
(Fig. 3-17,) Use a flat bladed screwdriver at the
location of the retainer spring and pull the retainer
forward and then off the perimeter of the boot.
Release these tabs in sequence from left to right
around the Touch Pad/LED Assembly until allof
the tabs are free and the Assembly can be lifted
from the console. (Fig.3-9)
Tab
Tabl
DOOR AND DOOR SWITCH
Ease the edge of the boot off of the lip of the
washer front near the door switch. (Fig. 3-12)
Remove enough of the boot to gain access to
the door switch behind the washer front panel.
Boot
Pulled
Back
Fig. 3-12
The door switch is secured to the washer front
panel with three screws. Once these screws are
removed, the door switch will remain in place until
it is lifted slightly and pulled back from the washer
front panel.
Retainer
Spring
Fig.3-9
Screws
Fig. 3-t 1
3 - 3
F i g . 3 - 1 3