Natural Gas - Cal Flame 2008 Owner's Manual

Barbecue grills and carts
Table of Contents

Advertisement

Installation / Assembly

Natural Gas

Requirements
Always check the rating plate to make sure the gas
supply you are hooking up to is the gas type the grill is
manufactured for.
IMPORTANT: Never connect the grill to an unregulated
gas supply.
The installation of this appliance must conform with local
codes or, in the absence of local codes, to the national
fuel gas code, ANSI Z223.1a-1998. Installation in
Canada must be in accordance with the standard CAN/
CGA-B149.2, Propane Installation Code.
A licensed contractor or local gas company representative
must perform all natural gas connections.
Ensure that the service supplying the grill is fitted with a
shut off valve conveniently positioned near the grill and
giving ease of access.
The grill must be isolated from the gas supply piping
system by closing its individual manual shutoff valve
during any pressure testing of the gas supply piping
system at test pressures equal to or less than 0.5 psi
(3.5 kPa).
The grill and its individual shutoff valve must be
disconnected from the gas supply piping system during
Page 8
any pressure testing of that system at test pressure in
excess of 0.5 psi (3.5 kPa).
Your Cal Flame™ grill for use with natural gas comes
equipped with its own regulator that MUST NOT be
removed. If, this regulator needs to be replaced use only
the type specified by Cal Flame™ for this appliance.
Connection
1.
Remove the rear panel from the barbecue to gain
access to the regulator and gas connection point.
2.
Connect a suitable flex connector to the grill
regulator.
3.
Check the grill controls to ensure all control valves
are in the full OFF position.
4.
Turn on the main gas supply and check all connections
for leaks using soapy water as described in the leak
testing procedure section.
Warning: If you see bubbles in the soapy solution at any
of the connections, turn off the gas supply and tighten
the connection. If tightening the connection does not
seal the leak, it may be necessary to replace the flex
hose.
2008 Barbecue Grill and Cart Owner's Manual
LTR20081038, Rev. B

Advertisement

Table of Contents
loading

Table of Contents