Preparation - Dimplex QM070 Installation Instructions Manual

Preparation

1. Place the heater fl at on the ground with arrows
printed on the base of the carton pointing upwards.
Open the carton at the bottom, slide the heater out
of the carton by at least 200mm exposing the feet
and the fi xing kit located within the packaging on
the right hand side. Remove the feet and the fi xing
kit.
Fig. 1
2. Secure the feet to the heater. For models QM070
and QM100 two locations are possible indicated by
X and Y markings visible on the base of the heater.
Y
X Y
X
Ensure the feet are fi xed at the location holes
X
marked with an ' ', see Fig. 2.
However, if this is a replacement heater check the
pitch of the feet and choose the appropiate fi xing
positions - either X or Y.
Note - Foot screws are in the fi xing kit.
Fig. 2
X
Y
X
Y
Stand the heater on its feet before removing the
packaging.
Fig. 2 Dispose of the packaging in an appropriate way.
Read these instructions carefully before
proceeding any further with the installation.
- 4 -