Table of Contents
Advertisement
Plumb adjustment (fig. D2)
• Place the tool into the required position as shown.
• Switch on the tool to initiate the leveling
procedure. As the leveling procedure for plumb
applications only requires adjustment of the Y axis,
only the corresponding leveling indicator (17) will
be operational.
Manually adjusting the level position (fig. A)
By using the remote control the tool can be adjusted
manually. The manual adjustment mode is
particularly useful in applications with slope angles in
both X and Y-axis.
• To activate the manual adjustment mode press the
key (22). The leveling indicators (16 & 17) go off.
• Use the keys (20) to adjust the tool in the X-axis.
• Use the keys (21) to adjust the tool in the Y-axis.
• To discontinue the manual adjustment mode,
press the key (22) again.
After discontinuing the manual leveling
mode the self-leveling feature
automatically takes over and re-adjusts
the tool to level position. The manual
adjustments will be lost immediately!
Aligning the laser line (fig. A & E1 - E5)
Level alignment
• With the tool switched on and the laser head
rotating, align the laser line with the position
mark.
• If adjustment is required, proceed as follows:
With tool in floor set-up (fig. E1):
• The tool can be placed on any sturdy object to
obtain the required height.
With tool in wall set-up (fig. E2):
• Loosen the locking knob (5) and adjust the rack
pinion wheel (9) to set the tool to the correct
position. Tighten the locking knob (5).
With tool in tripod set-up (fig. E3):
• Adjust the tripod to set the tool to the required
height.
Plumb alignment (fig. A, E4 & E5)
• With the tool switched on and the laser head
rotating, align the laser line with the position mark.
• If adjustment is required, proceed as follows:
• Use the keys (20) to move the laser head until the
laser line aligns with the position mark (fig. A).
Slope alignment (fig. A)
If the application requires the laser line to align at a
slope angle, proceed as follows:
• With the tool switched on and the laser head
rotating, activate the manual leveling mode.
• Align the laser line with the slope:
- Use the keys (20) to adjust the tool in the X-
axis.
- Use the keys (21) to adjust the tool in the Y-
axis.
Instructions for use
Always observe the safety instructions
and applicable regulations.
• Always mark the center of the laser line or dot.
• To increase working distance and accuracy, set
up the tool in the middle of your working area.
• Make sure the tool has been set up securely.
• Extreme temperature changes cause movement
of internal parts that may affect the accuracy of
the tool. Regularly check the accuracy while
using the tool under these circumstances.
• Although the tool corrects small out-of-level
errors automatically, when it has registered a
bump, re-adjustment to balance or set-up may
be required.
• If the tool has been dropped or has tipped over,
have the laser head calibrated by a qualified
repair agent.
• For your own comfort, always use the remote
control to operate the tool. The remote control
not only allows you to operate the tool from a
distance, it also keeps you from touching the
tool, thereby reducing the risk of affecting the
tool's balance and set-up.
Switching on and off (fig. A)
• To switch the tool on, press the on/off switch (1).
• To switch the tool off, press the on/off switch (1)
again.
Setting the rotation speed (fig. F)
The laser head can be set to different rotation speed
settings, thus determining the quality of the line.
E N G L I S H
39
Hide quick links:
Advertisement
Table of Contents
