EverFocus EAN900 Installation Manual page 5

re-plugged.
○,
Ethernet RJ-45 port: Connect to LAN via this standard RJ-45 connector.
3
Optional: This socket can also be used to power via PoE (Power over
Ethernet)
Yellow indicator light: On means 100Mbps, Off means 10Mbps.
Green indicator light: On means link, flicking means active, Off means link
fail.
○,
Reset: Loading factory default configuration by pressing the button, which is
4
inside this hole. Please insert the keen-edged device to the hole for 10 seconds.
○,
Power LED: There are five kinds of LED flash mode. The cycle of LED
5
flash is one second. The duration of each single bit is 0.1 second. LED display is
represented by number 0 & 1; 0 means light on, 1 means light off.
System Status
Power ON
Power OFF
SD card formatting
SD card is inserted
Firmware updating
○,
Alarm: Connect to Alarm In/Out device.
6
○,
RS485 (+-): Functionality reserved.
7
○,
GND: Ground pin.
8
○,
Power 12VDC: Connect with power adaptor.
9
○,
Audio In: 3.5mm stereo socket for line-in signal.
10
○,
Audio Out: It can be connected to an active speaker with a built-in amplifier
11
or a pair of headphones. A 3.5mm audio connector must be used for the audio out.
○,
Microphone: A built-in microphone used to receive audio message.
12
○,
Internal sensor: Day/Night switch sensor.
13
○,
Auto iris lens connector
14
This connector is used to connect with the auto iris lens by a 4 pin male connector
Pin 1
Direct Drive Cnt-
3. Power on the EAN900 via plug in the Adapter or via PoE (Power over
Ethernet).
LED Flash mode
1111111111
0000000000
1101100000
0111111111
0101010101
Pin 2 Pin 3
Cnt+ Drv+ Drv-
5
Pin 4
3
1
EAN900
4
2