Configure[1][:Scalar][:Power:ac] [<Expected_Value>[,<Resolution>[,<Source List>]]] - Agilent Technologies U2000 Series Manual

2 MEASurement Commands
CONFigure[1][:SCALar][:POWer:AC]
[<expected_value>[,<resolution>[,<source list>]]]
This command is used on the current window/measurement to set:
• The expected power level of the measurement.
• The resolution of the window/measurement..
Syntax
CONF
1
Parameters
Refer to
parameters in this command.
72
:SCAL :POW
Space expected_value
DEF
"Optional Parameters"
Item Description/Default
expected_value A numeric value for the expected power
level. The units of measurement are dBm
and W. The default units are defined by
UNIT:POWer.
resolution A numeric value for the resolution. If
unspecified the current resolution setting is
used.
:AC
,
resolution
DEF
on page 67 for additional details on the
,
source list
Range of Values
Sensor dependent.
1
DEF
2
1 to 4
1.0, 0.1, 0.01, 0.001
1
DEF
U2000 Series Programming Guide