Extension Cords - Chicago Electric 66745 Set Up And Operating Instructions Manual

grounded tools: tools with three
prong plugs
1. Tools marked with "Grounding Re-
quired" have a three wire cord and
three prong grounding plug. The
plug must be connected to a properly
grounded outlet. If the tool should
electrically malfunction or break
down, grounding provides a low
resistance path to carry electricity
away from the user, reducing the risk
of electric shock. (see 3-prong plug
and Outlet.)
2. The grounding prong in the plug is
connected through the green wire in-
side the cord to the grounding system
in the tool. The green wire in the cord
must be the only wire connected to
the tool's grounding system and must
never be attached to an electrically
"live" terminal. (see 3-prong plug
and Outlet.)
3. The tool must be plugged into an
appropriate outlet, properly installed
and grounded in accordance with all
codes and ordinances. The plug and
outlet should look like those in the
preceding illustration. (see 3-prong
plug and Outlet.)
SKU 66745 For technical questions, please call 1-800-444-3353.
double insulated tools: tools
with two prong plugs
1. Tools marked "Double Insulated" do
not require grounding. They have
a special double insulation system
which satisfies OSHA requirements
and complies with the applicable
standards of Underwriters Labora-
tories, Inc., the Canadian Standard
Association, and the National Electri-
cal Code. (see Outlets for 2-prong
plug.)
2. Double insulated tools may be used
in either of the 120 volt outlets shown
in the preceding illustration. (see
Outlets for 2-prong plug.)

eXtensiOn cOrds

1. Grounded tools require a three wire
extension cord. Double Insulated
tools can use either a two or three
wire extension cord.
2. As the distance from the supply outlet
increases, you must use a heavier
gauge extension cord. Using exten-
sion cords with inadequately sized
wire causes a serious drop in voltage,
resulting in loss of power and pos-
sible tool damage.
(see table a.)
Page 9