To Install Rip Fence; To Assemble Storage Brackets; To Store Accessories - RIDGID R4511 Operator's Manual

TO INSTALL RIP FENCE
See Figures 40
-
41.
• Place the rear clamp under the rear rail of the saw table
and pull slightly toward the front of the unit
Lower the front end of the rip fence onto the guide
surfaces on top of the front rail.
Push the locking handle down to automatically align and
secure the fence. When securely locked, the locking
handle should point downward.
Checkfora smooth gliding action. If adjustments are needed,
see To Check the Alignment of the Rip Fence to the Blade
in the Adjustment section of this manual.
TO ASSEMBLE STORAGE BRACKETS
See Rgure 42.
Secure the wrench holder to the left side of the leg stand.
Insert screws and tighten securely.
Secure the two storage brackets to the left side of the
leg stand. Insert screws and tighten securely.
TO STORE ACCESSORIES
See Figure 43.
The table saw has two convenient storage areas specifically
designed for the saw's accessories.
When not in use, store accessories in the storage area.
27