Theft Alarm - Dodge Challenger 2013 User Manual

THEFT ALARM

To Arm
• Keyless Enter-N-Go™ button installed:
Press the Keyless Enter-N-Go™ Start/Stop
button until the Electronic Vehicle Infor-
mation Center (EVIC) indicates that the
vehicle ignition is "OFF". Press the power
door lock switch while the door is open,
press the Key Fob LOCK button, or with one
of the Key Fobs located outside the vehicle
and within 5 ft (1.5 m) of the driver's and
passenger front door handles, press the
Keyless Enter-N-Go™ LOCK button located
on the door handle.
• Keyless Enter-N-Go™ button not installed: Turn the ignition switch to the "OFF" position.
Press the power door lock switch while the door is open, press the Key Fob LOCK button,
or with one of the Key Fobs located outside the vehicle and within 5 ft (1.5 m) of the driver's
and passenger front door handles, press the Keyless Enter-N-Go™ LOCK button located
on the door handle.
NOTE:
After pressing the Keyless Enter-N-Go™ LOCK button, you must wait two seconds before
you can lock or unlock the vehicle via the door handle.
To Disarm
• Keyless Enter-N-Go™ button installed: Press the Key Fob UNLOCK button or with one of
the Key Fobs located outside the vehicle and within 5 ft (1.5 m) of the driver's and
passenger front door handles, grab the Keyless Enter-N-Go™ door handle and enter the
vehicle, then press the Keyless Enter-N-Go™ Start/Stop button (requires at least one valid
Key Fob in the vehicle).
• Keyless Enter-N-Go™ button not installed: Press the Key Fob UNLOCK button or with one
of the Key Fobs located outside the vehicle and within 5 ft (1.5 m) of the driver's and
passenger front door handles, grab the Keyless Enter-N-Go™ door handle and enter the
vehicle, then turn the ignition to the ON/RUN position.
GETTING STARTED
13