Moving A Frequency From A Monitor Memory To A Channel; Deleting A Frequency From A Channel; Scanning Channels - Radio Shack 200 Ch VHF/Air/UHF Home Scanner Owner's Manual

You can also select a monitor memory
by repeatedly pressing
the desired monitor memory appears.
Note: To listen to the monitor memories,
the priority channel feature must be
turned off (see "Priority" on Page 20).
MOVING A FREQUENCY
FROM A MONITOR
MEMORY TO A CHANNEL
1. If the scanner is scanning, press
.
MANUAL
2. Use the number keys to enter the
channel number where you want to
store the monitor frequency, then
press
PROGRAM
3. Press
MONITOR
ber flashes and the frequency
stored in the monitor memory and
the monitor
appear.
4. Use the number keys to enter the
monitor memory number that has
the frequency you want to store into
the channel. The frequency ap-
pears.
5. Press . The scanner stores the fre-
E
quency in the selected channel.
until
MONITOR
PGM
. appears.
. The channel num-
memory's number
DELETING A FREQUENCY
FROM A CHANNEL
1. If the scanner is scanning, press
.
MANUAL
2. Use the number keys to enter the
channel number containing the fre-
quency you want to delete.
3. Press
PROGRAM
4. Press then
0
deleted.
To replace a frequency stored in a moni-
tor memory, store a new frequency in
that monitor memory.

SCANNING CHANNELS

Note: You cannot scan channels until
you have stored frequencies in them.
To scan channels stored in the channel-
storage banks, press
ner scans through all channels in the ac-
tive banks.
To select one or more channel-storage
banks while scanning, select each bank
you want to scan by pressing its number
key so the bank's number appears on
the display.
Note: The channels for each bank are
listed above the scanner's number keys.
To turn off channel-storage banks, press
the number key for each of the bank(s)
so the bank's number disappears. The
scanner does not scan any of the stored
channels within banks you have turned
off.
.
. The frequency is
E
. The scan-
SCAN
17