Table of Contents
Advertisement
3. Installation Locations
• Do not obstruct the vents located on the alarm. Do not place the
alarm where drapes, furniture or other objects block the flow of air to
the vents.
• Do not install on a switched or dimmer-controlled outlet.
4. Installation Instructions
How to Install Your Alarm
Direct Plug Alarm
To install:
1. Choose a standard
120 V unswitched
outlet to plug the
alarm into.
2. Write the date ten years from installation on the Replace by sticker on
the CO alarm.
3. If desired, activate the Power-Disconnection Alert Switch by moving
the Power-Disconnection Alert Peg away from the Tamper Resist
Activation Switch. The tamper resist feature signals a loud 85dB alarm
should the unit become unplugged or loose from the outlet. (See
Power-Disconnection Alert details in the Product Features and
Specifications section.)
4. Pull the yellow tab to activate the battery backup.
5. Plug the alarm into the outlet.
CAUTION: Do not rotate the alarm while it is plugged into an outlet, as
damage to plug may result.
5. Alarm Characteristics
Carbon Monoxide Alarm Indicator
When the alarm senses a dangerous level of CO, the unit will emit a
loud alarm pattern. The alarm pattern is 4 quick beeps followed by 5
seconds of silence. This cycle repeats as long as a dangerous CO
conditions exist. The red Alarm LED will flash the same pattern.
WARNING: When powered by battery backup only; after four
minutes, the alarm will sound and flash only once every minute, until
the alarm is reset or the CO is eliminated.
Tamper-Resist
Activate Slide
Tamper-Resist
Activation Switch
(see Normal Operating
Characteristics)
Hide quick links:
Advertisement
Table of Contents
