Fitting The Handles - Westinghouse Ice + Water French Door User Manual

3 . Check the alignment of the refrigerator to the
surrounding cupboards to see if it is level . You can
adjust the level with the rollers as detailed in step 3 .
Aligned to
cupboards
ie . even gap
4 . If you find your refrigerator rocks from corner to corner,
it means your floor is uneven . Find a piece of plastic or
hardboard etc . and pack it firmly under the roller .
5 . On certain floor surfaces the refrigerator may roll
forward during operation . A "Roller Stop", which is
provided, can be placed under the front rollers .
Roller stop
6 . You may now need to fine-tune the installation by
repeating Steps 3, 4 and 5 .
A (top)
B (right)

FIttINg tHE HANDLES

1 . Remove the handles from the packaging
2 . Fit the refrigerator handle by aligning the handle with
Top of refrigerator is
3 . Pull the handle down until you hear a "click"
level ie . horizontal
4 . Repeat this with the other refrigerator handle .
Adjust front rollers
for uneveness of
floor eg . wind this
roller down or up
5. Next, fit the freezer handle (B). (model WHE5100 only)
6 . Align the freezer handle with the mounting location on
7 . Pull the handle to the left until you hear a "click"
8 . Clean your refrigerator thoroughly following the
9 . Plug your refrigerator straight into its own power point
10 . Before you put any food in your refrigerator, it is
the mounting locations on the door (as shown below in
illustration A) . Ensure that the handle end marked "TOP"
is aligned with the top mounting location on the door .
the freezer door, ensuring that the end marked "Right" is
aligned with the mounting location on the right side of
the door .
instructions on page 15 and wipe off any dust that has
accumulated during shipping .
and never use a double adapter .
recommended you leave it on for 2 or 3 hours to check
it is running properly and the appropriate temperature
is reached .
A (refrigerator handles)
B (freezer handle)
Installation 7