Installing Door Handles - Westinghouse WHE6874 User Manual

Flipper Mullion
Adjust Flipper Mullion for proper connection
with the mullion guide by ensuring the flipper
mullion is folded and perpendicular to the fresh
food door. If the mullion guide is not in the
correct position, it could prevent the door from
closing completely.

INSTALLING DOOR HANDLES

CAUTION
Wear gloves and safety goggles. Use extreme
CAUTION when installing these handles.
Door Handle Mounting Instructions
1. Remove handles from carton and any other
protective packaging.
2. Position refrigerator handle end caps over
upper and lower pre-installed shoulder bolts
(A) that are fastened into door, ensuring the
holes for the set screws are facing towards
the opposite door.
3. While holding handle firmly against door, fasten
upper and lower Allen set screws (B) with
supplied Allen wrench.
4. Repeat steps 2 and 3 to install opposite handle.
Ensure the holes for the set screws are facing
towards the first door.
5. Position freezer/FlexSpace
Drawer handle end caps over left and right pre-
installed shoulder bolts (A) that are fastened to
the door, ensuring the holes for the set screws
are facing down.
6. While holding handle firmly against door,
loosely tighten right Allen set screw (B) with
supplied Allen wrench until there is no gap
between handle and door.
7. Still holding the handle firmly to the door, firmly
tighten left Allen set screw (B) with supplied
Allen wrench.
8. Return to the right Allen set screw (B) and firmly
tighten with supplied Allen wrench.
Note: All set screws should be tightened so
the screw is below the surface of the
handle. The handles should be drawn tight
to doors/drawer with no gaps. Opening
the opposite door while tightening the
Allen screw makes installation easier.
The door handle may loosen over time or if it
was incorrectly installed. If this happens,
tighten the set screws on the handles.
TM Convertible
7