Fitting The Handles - Westinghouse French Door User Manual

INSTALLATION

FITTING THE HANDLES

4 . Check the alignment of the refrigerator to the
surrounding cupboards to see if it is level . You can
adjust the level with the rollers as detailed in step 3 .
Aligned to
cupboards
ie . even gap
5 . If you find your refrigerator rocks from corner to corner,
it means your floor is uneven . Find a piece of plastic or
hardboard etc . and pack it firmly under the roller .
6 . On certain floor surfaces the refrigerator may roll
forward during operation . A "Roller Stop", which is
provided, can be placed under the front rollers .
Roller stop
7 . You may now need to fine-tune the installation by
repeating Steps 3, 4 and 5 .
Top of refrigerator is
level ie . horizontal
Adjust front rollers
for uneveness of
floor eg . wind this
roller down or up
A (top)
B (right)
1 . Remove the handles from the packaging
2. F it the refrigerator door first (A) by aligning the handle
with the mounting locations on the door. (as shown
below) ensuring that the handle end marked "TOP" is
aligned with the top mounting location on the door .
3 . Pull the handle down until you hear a "click"
4 . Repeat this with the other refrigerator handle .
5. N ext, fit the freezer handle (B). (model WHE5100SA only)
6 . Align the freezer handle with the mounting location on
the freezer door, ensuring that the end marked "Right" is
aligned with the mounting location on the right side of
the door .
7 . Pull the handle to the left until you hear a "click"
8 . Clean your refrigerator thoroughly following the
instructions on page 15 and wipe off any dust that has
accumulated during shipping .
9 . Plug your refrigerator straight into its own power point
and never use a double adapter .
10 . Before you put any food in your refrigerator, it is
recommended you leave it on for 2 or 3 hours to check
it is running properly and the appropriate temperature
is reached .
A (refrigerator handles)
B (freezer handle)