Table of Contents
Advertisement
12.0
CHANGING COMPONENTS
12.21 Diverter Valve Assembly (Cant)
CH Pressure Differential Valve (Fig. 71)
1. Remove the DHW pressure differential valve as
described above.
2. From the brass diverter manifold undo the nut on
the heating flow pipe. Remove the screw securing the
diverter manifold to the appliance lower bracket.
3. Disconnect the pressure gauge capillary from the
diverter manifold and remove the two wires from the
microswitch,
4, Prise off the spring clip securing the by-pass pipe
to the diverter manifold and disconnect the sensing
pipe.
5. Ease the diverter manifold out of the plate heat
exchanger manifold. Remove the assembly from the
appliance.
6. Undo the screw securing the microswitch bracket to
the valve body. The sensor may now be dismantled to
examine the diaphragm.
7. To examine the diaphragm hold the assembly
securely and carefully remove the four screws. The
diaphragm spring will force the two halves of the valve
apart.
8. Carefully examine the diaphragm and replace it if
there is any damage.
9. Reassemble in reverse order.
CH Pressure
Microswitch
(Fig. 71)
1. Remove the two wires from the pressure
microswitch.
2. Undo the screw securing the microswitch bracket
to the valve body.
3. Reassemble in reverse order.
12.22 Flow Regulator (Figs. 71 & 72)
1. Undo the filter cartridge from the inlet/return
manifold,
2. Unscrew the venturi and remove the flow regulator.
3. Check the cleanliness of the filter gauze, rinsing
thoroughly in clean water as necessary. Fit the new
flow regulator and reassemble in reverse order.
Microswitch &
Central Heating
Bracket
Pressure Differential
""
Valve
se.7ng Pipe
DI,phffi~m
~I
~
By-
""" ~,'
~"""",'PIPe
10
l\fi~
-
~
/
~
Spring Clip
/
&;~~~1
DI"rte,
Maol'old
-~
. Pressure'Gauge
Capillary
~~
Fig. 85
~
Flow.."""
Regulator
Heating
Flow Pipe
Fig. 71
~?~,:,e
.'
.
.'
.
"
.
.'
:
/
.
.'
.
.'
.
.'
:
/
.
"
:
/
:/ ,.
Filter Gauze
Inlet / Return Manifold
Fig. 72
Venturi
3/
Advertisement
Table of Contents
