Reset Domestic Hot Water Hot Water will operate. Central Heating Indicator - The indicator will illuminate when the boiler is in the central heating mode. Domestic Hot Water Indicator - The indicator will illuminate when hot water is being supplied to a tap or shower.
Select Switch in the ) position and Central Heating the display lit ? Indicator Display Check electricity to the boiler is switched on. 2.0 Troubleshooting Is the ( ) or ( ) light on and the ( ) on ?
However, even if your boiler has an external loop, the principle is similar. 2. Look at the boiler from underneath. There will be two taps at the end of copper pipes, one with a blanking cap on the end. Do not operate these taps yet.
Left side Right Side 200mm Min Front 7. If your boiler is installed in a compartment, do not use it for storage purposes. Do not obstruct any purpose provided ventilation openings. 8. Flammable materials must not be stored in close proximity to your boiler.
To prevent seizure, the pump will operate for approximately 1 minute if it has not run in the last 24 hours. Fault Indication 1. If a fault occurs on the boiler an error code may be shown on the facia display (Fig.
Product/Production certified by: Notified Body 0085. For GB/IE only. 1. Please ensure that your installer hands you the boiler Installation & Service Instructions with the “Benchmark Commissioning Checklist sections completed. The details in the Checklist will be required in the event of any warranty work.
Turn off the gas supply at the meter and call your gas supplier immediately. It is possible to isolate the boiler at the isolating valve (Fig. 9). In GB, Transco operate a 24 hour emergency service and the telephone number will be listed in your telephone directory.
08706 017 017. Our promise to you If you experience a fault with your new boiler, we aim to provide a safe and high quality repair service supported by our dedicated national network of highly skilled engineers. If your installer can’t resolve the problem for you, we will do everything we can to get an engineer out to you as quickly as possible.