Table of Contents
Advertisement
12.0
CHANGING COMPONENTS
12.17
Pressure Relief Valve (Fig. 65)
1. Drain the primary circuit.
2. Disconnect the discharge pipe from the valve.
Using a suitable hexagon key undo the grub screw
sufficiently to release the valve.
3. Note the orientation of the valve, rotate it and
withdraw it from the manifold.
4. Fit the new valve and '0' ring seal and set to the
previously noted orientation. Reassemble in reverse
order.
12.18 P.C.B. (Fig. 67)
1. Note the settings of the temperature control knobs.
Rotate the knobs fully anticlockwise and pull them off
the drive pins.
2. Completely undo the screws securing the control
box cover and release the cover retaining barbs from
their slots. Disengage the rear of the cover from the
control box hinge pin (Fig. 66).
3. Note the position of all plugs and wires on the
P.C.B. and disconnect them. Pull the drive pins off the
P.C.B.
4. Undo the securing screws and remove the P.C.B.
5. Reassemble in reverse order, ensuring that the
temperature controllers are reset to their previous
positions.
12.19
Selector Switch (Fig.
67)
1. Note the setting of the selector switch knob and
carefully pull it off the facia.
2. Completely undo the screws securing the control
box cover and release the cover retaining barbs from
their slots. Disengage the rear of the cover from the
control box hinge pin (Fig. 66).
3. Note the position of the electrical connections and
the orientation of the switch. Remove the electrical
connections.
4. Remove the screws securing the switch to the facia
panel.
5. Fit the new switch, ensuring that it is correctly
positioned and reassemble in reverse order.
'0' ring seal """
~
~
..
/~
~........
0
Grub Screw
.
~
Pressure Relief Valve
FI9.65/~
~
Discharge Pipe
Fig. 66
Control Box Cover
P.C.B.
Selector
Switch ".
i~
Fig. 67
Facia
.........
11j(l1
Selector Switch Knob
I
,1
~
I
"
I
.
~~
:::::::::..
Temperature
Control
0"""
Knobs
35
Advertisement
Table of Contents
