Dockside Wizard; Starting The Wizard; Set Drive Type - Raymarine ST70+ Operating Manual

Chapter 2: Commissioning Procedures

Dockside wizard

Starting the wizard

At a convenient Pilot Controller:
MENU
1. Press
2. Scroll to Autopilot calibration then press
tion menu.
3. Scroll to select Commissioning then press
to display the Commissioning menu.
4. Scroll to Dockside wizard then press
the wizard. The Dockside Calibration page is
displayed.

Set drive type

With the Dockside calibration page displayed at the
selected Pilot Controller, press
associated keypad to display the Drive type page
then:.
1. Scroll to select the autopilot drive type appropri-
ate to your boat.The options available depend
on the type of autopilot, but options supported
are:
Type 1 Linear
Type 2 Linear
Type 2 Hydraulic Linear
Type 3 Hydraulic Linear
I/O Stern
IPS
Jet Drive (pump)
Note:
If your drive type is not included, seek advice from your Raymarine dealer.
2. Press OK to save your setting and display the next setup page. This is either:
• The Rudder check (center) page, if the boat has a rudder reference transducer,
or
• The Motor phasing non-referenced page, if a rudder reference transducer is
not fitted.
OK
3. Press
either Systems with a Rudder Reference transducer or Systems without a Rudder
Reference transducer, as appropriate.
to display the Main Menu.
OK
Jet Drive (fly-by-wire)
Wheel Drive
Tiller
CR Solenoid
Sport Drive
Rotary Drive Type1
Rotary Drive Type 2
to proceed with the Rudder and motor checks. Use the procedure for
OK
to display the Autopilot Autocalibra-
OK
Dockside Calibration
OK
to start
Drive Type
on the
i
Hydraulic Pump Type 1
Hydraulic Pump Type 2
Hydraulic Pump Type 3
Constant Running Pump
Verado
Before you can use your
autopilot you need to do
some dockside checks.
Press CANCEL to exit
without saving.
Press OK to continue
Type 1 Linear
CANCEL returns to the previous page.
Press OK to select
21