Display Types & Grouping - Raymarine ST70+ Operating Manual

6
The initial setup procedure enables you to:
• Select system language.
• Select vessel type.
• Set up display types & groups (see Figure 1-2 )
• Set time and date formats.
• Set local time value.
• Set units.
Display types & grouping
System
From
configuration
Vessel type
setup
Configure
this display
all displays &
groups set as
required?
Display type
To be the same type for all
displays in a Group
Link keypad
to group
Figure 1-2: Display type & group setup summary
During initial setup, you allocate each ST70+ display as either an Instrument or a Pilot
Controller, then define groups of Instruments and Pilot Controllers (see Figure 1-2: ,
Display type & group setup summary). Each group is controlled by a common keypad
or keypads. For example, you could group together all Instruments fitted at the helm
and control them with a single keypad.
When grouping displays together, the following rules apply:
• All displays in a group must be set to be the same type, i.e. all Instruments or all
Pilot Controllers.
• A 'group' can be just one display, or a number of displays up to a maximum of four.
• The keypad(s) allocated to a group must be appropriate to the display function, i.e.
Instrument keypad for Instrument groups, Pilot Controller keypad for Pilot Control-
ler groups.
OK
Are
YES
MENU
NO
Select display to assign function and allocate to group
OK
Assign group
OK
On keypad you want to link,
YES
Link keypad
to this group?
NO
MENU
ST70+ User Reference Manual
To be different for each
display in a Group
Assign order
OK
in group
press
Link keypad
Keypad linked
OK
to group
Popup
To
Time & Date
summary
OK
OK