Freestanding Installation; Stove Components; Clearance To Combustibles And Non-Combustibles - Appalachian Stove & Fabricators Trailmaster 4N1-XL Installation And Operation Procedures

III. FREESTANDING INSTALLATION

1. STOVE COMPONENTS

The following components are included with the 4N1-
XL freestanding model:
(A) 4N1-XL stove
(B) Blower assembly
(C) Pedestal or Brass Legs (4 req) - (Not Shown)
(D) Refractory Fireplace Liner (firebrick)
(E) Assembly Screws
(F) Outside Air Duct (Mobile Home Only)
(G) Ash Pan
(H) Damper Spring
FIGURE 5 - STOVE COMPONENTS
2. CLEARANCE TO COMBUSTIBLES AND NON-
COMBUSTIBLES
The 4N1-XL stove MUST be installed with adequate
clearance from combustible surfaces to assure safe
operation. Refer to FIGURE 6 to determine the
applicable clearances for your installation.
Rear and side wall clearances depend on two factors:
1. Composition of the wall structure (combustible or
non-combustible materials).
2. Type of stove pipe used to connect the stove to
chimney or flue (single wall or double wall, insulated
pipe).
7