Table of Contents
Advertisement
V . INSTALLING THE BRASS TRIM
1. STANDARD BRASS
(A) SPRING DAMPER HANDLE
1. Screw the handle onto the damper rod counter-
clockwise.
2. OPTIONAL BRASS
(A) GOLD PLATED DOOR WEBBING/CAST WEBBING
1. For ease of installation, remove the door from the stove.
The door can be removed from its hinges with the proper
leverage.
2. The air channel can then be taken off by removing the
four screws. Remove the glass.
3. Place the webbing in the center of the opening. If the
door is cast and the webbing is brass, it may be a tight fit.
Make sure the webbing drops down completely.
NOTE: The door may also be replaced, if desired. It also
comes in the option of gold plated and cast black.
(B) BRASS TRIM PANELS
1. Mount top and side strips to trim panels with self
tapping screws, provided. Leave approximately 1" at top
edges of trim to be covered by corner brass. If needed,
strips can easily be cut with a hacksaw.
2. Mount two brass corners overlapping top and side brass
strips.
3. Remove protective coating from brass strips before use.
FIGURE 12
MOUNTING DAMPER ROD HANDLE
FIGURE 13
MOUNTING TRIM PANELS
12
Hide quick links:
Advertisement
Table of Contents
