Sony Cyber-shot DSC-RX10 Help Manual page 212

Help Guide | Capturing a basic white color in [Custom Setup] mode
Help Guide
How to Use
Digital Still Camera
DSC-RX10
Capturing a basic white color in [Custom Setup] mode
In a scene where the ambient light consists of multiple types of light sources, it is
recommended to use the custom white balance in order to accurately reproduce the whiteness.
1. MENU →
2. Hold the camera/camcorder so that the white area fully covers the AF area located in the
center, and then press
The calibrated values (Color Temperature and Color Filter) are displayed.
3. Select a registration number using the right/left side of the control wheel.
The monitor returns to the recording information display while retaining the memorized
custom white balance setting.
Note
The message [Custom WB Error] indicates that the value is higher than the expected range,
when the flash is used on a subject with too bright colors in the frame. If you register this
value, the
this point, but it is recommended that you set the white balance again to get a more
accurate white balance value.
http://www.sony-asia.com/microsite/cybershot_userguides/DSC-RX10/eng/contents/TP0000226592.html[24/11/2013 16:02:35]
(Camera Settings) → [White Balance] → [Custom Setup].
on the center of the control wheel.
indicator turns yellow on the recording information display. You can shoot at
Copyright 2013 Sony Corporation
Notes on use
4-477-079-12(1)