Sony VPL-FHZ55 Operating Instructions Manual page 30

Setting items
*10
Color Matching
Notes
*1: You cannot adjust anything other than the targeted adjustment zones in "Zone Black Level Adj."
*2: When selecting the correction zone of "Zone Black Level Adj.," the targeted correction zone
flashes twice.
*3: When "Edge Blending" is set to "On," "Screen Fitting" (HV Keystone/Warping) is not
displayed.
*4: Depending on the position adjusted with the lens shift feature, the aspect ratio of the image may
change from the original or projected image may be distorted with Keystone adjustment.
*5: Since the HV Keystone/Warping adjustment is an electronic correction, the image may
deteriorate.
*6: Select "Link to Image Flip" only for horizontal installation. Be sure to select "Front Up" or
"Front Down" for vertical installation, according to the installation direction of the projector.
(Refer to the figures.)
*7: In the case of a portrait installation, pay attention not to block the ventilation holes (exhaust/
intake).
*8: Do not use the projector at an altitude of 2,700 m or higher.
*9: Depending on the adjustment value of "Panel Alignment," the color and resolution may be
changed.
*10:The brightness and color of the projected image may not match completely, even after you adjust
"Brightness" and "Color."
*11:If the Screen Aspect is set to 16:10 and input signal is 16:10 or 16:9, the image will be projected
at the correct aspect. This function is not available when displaying two pictures.
30
The Installation Menu
Description
Adjust/Reset: For correcting the brightness and color of the whole
projected image manually from the signal level in six steps.