The Connection/Power Menu - Sony VPL-FHZ55 Operating Instructions Manual

The Connection/Power Menu

The Connection/Power menu is used for setting for the connections and power.
Setting items
Network Setting
IPv4 Setting
IP Address Setup
IP Address/ Subnet
Mask/ Default
Gateway/Primary
DNS/Secondary
DNS
IPv6 Information
Input-A Signal Sel.
Color System
ECO
Light Output Mode
Constant
*3
Brightness
Auto Power Saving
With No Input
26
The Connection/Power Menu
Description
Auto (DHCP): The IP address is assigned automatically from the
DHCP server such as a router.
Manual: To specify the IP Address manually.
When "Manual" is selected for "IP Address Setup," select the item
with the B or b key and input the value with V or v key. When all
items are entered, select "Apply" then press the ENTER key. The
entered settings will be registered.
Displays the IPv6 address information.
When setting the address of IPv6, set it from the browser.
Auto/Computer/Video GBR/Component: When set to "Auto,"
selects the type of video signal input automatically when "Input-A" is
selected with the INPUT key.
Auto/NTSC /PAL/SECAM/NTSC
3.58
to "Auto," selects the color system automatically when "S-Video" or
"Video" is selected with the INPUT key.
High/Standard/Auto/Custom
becomes brighter, and power consumption becomes higher. When set
to "Standard," power consumption becomes lower; however, the image
will be darker. When set to "Auto," brightness is adjusted
automatically according to image content. Dark images are projected
with brightness adjusted, leading to energy-saving. Bright images are
projected brightly, without adjusting brightness. When set to
"Custom," you can adjust brightness as prefer.
On/Off: Available when Light Output Mode is set to "High" or
"Standard." Brightness is constant at about 75% light output when
Light Output Mode is set to "High," and at about 55% when Light
Output Mode is set to "Standard."
Light Cutoff: The light turns off automatically and power
consumption is reduced if no signal is input for more than 10 minutes.
The light turns on again when a signal is input or any key is pressed. In
Light Cutoff, the ON/STANDBY indicator lights in orange. (page 35)
If Light Cutoff continues for more than 30 minutes, the power will cut
off automatically and the projector will go to standby mode.
*4
Standby : If no signal is input to the unit for more than 10 minutes,
the power turns off automatically, and the unit enters standby mode.
Off: The "With No Input" function is disabled.
*1
/PAL-M/PAL-N: When set
4.43
*1
*2
: When set to "High," the image