Air Cleaner - Briggs & Stratton 90000 Operator's Manual

MAINTENANCE

AIR CLEANER

CAUTION: Do not use pressurized air or solvents to
clean cartridge. Pressurized air can damage
cartridge; solvents will dissolve cartridge.
To Remove
PUSH TABS IN
WHILE PULLING
ON COVER TO
REMOVE
COVER
To Install
CARTRIDGE
COVER
REMOVING AND RE-INSTALLING AIR CLEANER
[1] Push in the tabs located on the sides of the air cleaner
cover, while pulling cover off.
[2] Remove cartridge carefully to prevent debris from
entering carburetor.
[3] Re-install new air cleaner assembly in base.
[4] Replace cover by snapping tabs back into place.
BASE
Pre-cleaner
To clean pre-cleaner (if equipped), separate it from
cartridge and wash in liquid detergent and water. Air dry
thoroughly. Do not oil. Re-install dry pre-cleaner on clean
cartridge.
CAUTION: Do not use pressurized air or solvents to
clean cartridge. Pressurized air can damage
cartridge; solvents will dissolve cartridge.
Ì Ì Ì Ì Ì Ì Ì Ì Ì
Ì Ì Ì Ì Ì Ì Ì Ì Ì
Ì Ì Ì Ì Ì Ì Ì Ì Ì
Ì Ì Ì Ì Ì Ì Ì Ì Ì
REMOVING AND RE-INSTALLING AIR CLEANER
[1] Loosen screws and remove cover.
[2] Remove pre-cleaner (if equipped) and cartridge
carefully to prevent debris from entering carburetor.
[3] Re-install clean (or new) air cleaner assembly in base.
[4] Replace cover and tighten screws.
10
SCREWS
COVER
PRE-CLEANER
P/N 491435
CARTRIDGE
P/N 491588
OR 5043
BASE