Table of Contents
Advertisement
1.2
Applicability
This manual is applicable to the Stanley Bluetooth Programming Adapter. This device can be
used for tune-in of an MC521 controller or StanVision sensor controller.
2.
PREREQUISITES
2.1
All four DIP switches have been set in the down position.
2.2
The area has been cleared of all obstructions.
2.3
Attachment 1 has been reviewed for the following:
Definitions of the terms used in this procedure
A listing of the documents, special tools and equipment, materials, and consumables used in
this procedure.
3.
PRECAUTIONS
3.1
AAA alkaline batteries can be used to power this unit. However, standard alkaline batteries are
not designed to be recharged and should never be placed in any battery charger. Attempting to
charge alkaline batteries will significantly increase the likelihood for battery leakage. Only use
the wall charger with NiMH-type rechargeable batteries.
3.2
If while trying to make a connection to the dongle a message indicates that a connection could not
be made, verify that power is on and that the green LED is flashing two times per second. Then,
try to make the connection again. (This may need to be repeated a couple of times.) If connection
is lost or out of range, turn power to the dongle off, close the application on the handheld device,
and try again.
© 2010, THE STANLEY WORKS. ALL RIGHTS RESERVED.
204063
Rev. B, 11/23/10
4 of 22
Advertisement
Table of Contents
