Safety Instructions; General - DeWalt DC410 User Manual

E N G L I S H

Safety instructions

When using power tools, always observe the safety
regulations applicable in your country to reduce
the risk of fire, electric shock and personal injury.
Read all of this manual carefully before operating
the tool.
Save this manual for future reference.

General

1 Keep work area clean
Cluttered areas and benches can cause accidents.
2 Consider work area environment
Do not expose the tool to rain. Do not use the
tool in damp or wet conditions. Keep the work
area well lit (250 - 300 Lux). Do not use the tool
where there is a risk of causing fire or explosion,
e.g. in the presence of flammable liquids and
gases.
3 Keep children away
Do not allow children, visitors or animals to come
near the work area or to touch the tool or the
mains cable.
4 Dress properly
Do not wear loose clothing or jewellery, as these
can be caught in moving parts. Wear protective
hair covering to keep long hair out of the way.
When working outdoors, preferably wear suitable
gloves and non-slip footwear.
5 Personal protection
Always use safety glasses. Use a face or dust
mask whenever the operations may produce
dust or flying particles. If these particles might be
considerably hot, also wear a heat-resistant
apron. Wear ear protection at all times. Wear a
safety helmet at all times.
6 Do not overreach
Keep proper footing and balance at all times.
7 Stay alert
Watch what you are doing. Use common sense.
Do not operate the tool when you are tired.
8 Secure workpiece
Use clamps or a vice to hold the workpiece. It is
safer and it frees both hands to operate the tool.
9 Connect dust extraction equipment
If devices are provided for the connection of dust
extraction and collection facilities, ensure that
these are connected and properly used.
22
10 Remove adjusting keys and wrenches
Always check that adjusting keys and wrenches
are removed from the tool before operating the
tool.
11 Use appropriate tool
The intended use is described in this instruction
manual. Do not force small tools or attachments
to do the job of a heavy-duty tool. The tool will
do the job better and safer at the rate for which it
was intended. Do not force the tool.
Warning! The use of any accessory or
attachment or performance of any operation with
this tool other than those recommended in this
instruction manual may present a risk of personal
injury.
12 Check for damaged parts
Before use, carefully check the tool and mains
cable for damage. Check for misalignment and
seizure of moving parts, breakage of parts,
damage to guards and switches and any other
conditions that may affect its operation.
Ensure that the tool will operate properly and
perform its intended function. Do not use the tool
if any part is damaged or defective. Do not use
the tool if the switch does not turn it on and off.
Have any damaged or defective parts replaced
by an authorised D
attempt any repairs yourself.
13 Remove the battery pack
Switch off and wait for the tool to come to a
complete standstill before leaving it unattended.
Remove the battery pack when not in use,
before changing any parts of the tools,
accessories or attachments and before servicing.
14 Avoid unintentional starting
Do not carry the tool with a finger on the switch.
Be sure that the tool is switched off before
inserting the battery pack.
15 Store idle tools
When not in use, tools must be stored in a dry place
and locked up securely, out of reach of children.
16 Maintain tools with care
Keep the tools in good condition and clean for
better and safer performance. Follow the
instructions for maintenance and changing
accessories. Keep all handles and switches dry,
clean and free from oil and grease.
WALT repair agent. Never
E