Maintenance; Switching On And Off; Lubrication; Cleaning - DeWalt DC410 User Manual

Switching on and off (fig. A)
• To run the tool, press the on/off switch (1).
• To stop the tool, release the switch.
• To lock the tool in off position, activate the safety
lock located next to the on/off switch.
Do not switch the tool on or off when
under load.
Consult your dealer for further information on the
appropriate accessories.

Maintenance

Your D WALT power tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.

Lubrication

Your power tool requires no additional lubrication.

Cleaning

• Unplug the charger before cleaning the housing
with a soft cloth.
• Remove the battery pack before cleaning your
power tool.
• Keep the ventilation slots clear and regularly
clean the housing with a soft cloth.
Environment
Rechargeable battery pack
This long life battery pack must be recharged when
it fails to produce sufficient power on jobs which
were easily done before. At the end of its technical
life, discard it with due care for our environment:
• Run the battery pack down completely, then
remove it from the tool.
• NiCd and NiMH cells are recyclable. Take them
to your dealer or a local recycling station.
The collected battery packs will be recycled or
disposed of properly.
Unwanted tools
Take your tool to an authorised D
agent where it will be disposed of in an
environmentally safe way.
E N G L I S H
WALT repair
E
27