Advanced Programming-Level 2
Slope Mode SL
See the Tire Pressure Monitoring System Setting Chart
on page 5-52 for setting value specifications.
The Slope is a value corresponding to the rate of
pressure change due to temperature for a particular tire.
This value affects the calculation to determine pressure
deviation value. The factory default setting is 44.
To Program
1. Enter Level 2 Program
3. Press the MODE button to display the current value
4. Press the TIRE button to increase the value.
ming Mode, see
Entering Programming
5. Press the MODE button to decrease the value.
Mode.
6. Press the SET button to save the value.
7. Press the SET button to exit.
8. Press the SET again to revert to normal mode.
2. Press the TIRE button to
scroll to the desired axle,
the tires of the selected
axle are filled in.
of slope for the selected axle.
The minimum value is 10 and the maximum is
160.
Repeat steps 2-6 until the slope level is set for all
axles as desired.
5-45