Door Assembly; Fan Motor - Panasonic NN-CS596S BPQ Service Manual

NN-CS596S
4.6.

Door assembly

1. Remove left and right door key springs from door arm with
plier.
NOTE:
Please support door before operation.
To remove door C and door A (U)
• • • • Insert flat blade screwdriver to release hinge pin
from left hinge.
• • • • Release catch hooks between door C and door A, to
detach the door C.
Release catch hooks.
NOTE:
After replacement of the defective component
parts of the door, reassemble it and follow
the instruction below for proper installation
and adjustment so as to prevent an excessive
microwave leakage. Adjustment of the door
assembly.
2. When mounting the door to the oven, be sure to adjust the
door parallel to the cavity front plate by moving hinges back
or front.
NOTE:
Upper portion of door A should firmly touch the
cavity front plate without pushing.
NOTE:
Be sure the gap between lower portion of door A
and cavity front plate should be less than 0.5mm.
4.7.

Fan motor

1. Disconnect 2 lead wires from fan motor terminals.
2. Remove 2 screws holding air guide B on magnetron & on
base plate respectively, then remove air guide B.
3. Remove 2 screws holding fan motor and detach fan motor
from oven assy.
4. Remove fan blade from fan motor shaft by pulling it straight
out.
14