Remote Control Receiver Installation (2 Options) - Travis Industries 864 ST Installation Manual

Optional Equipment

Remote Control Receiver Installation (2 Options)

The instructions below detail installation of the optional remote control receiver. For operating
instructions, refer to the instructions included with the remote.
OPTION # 1 - Remote Thermostat (99300653)
Attach the power cord to the
electrical receptacle on the inside
of the fireplace.
OPTION # 2 - Remote Thermostat (99300677) NOTE: Blower required for this remote.
© Travis Industries
WARNING: Make sure the power cord does
not contact the blower (if applicable) or the
bottom of firebox (or other hot surface).
Use lock-ties or wire ties to
shorten the power cord to
approximately 12" length.
Attach the two reciever wires to the
top and bottom posts on the gas
control valve (orientation does not
matter).
(for qualified installers only)
Place the receiver in a location to
the left of the gas control valve
(near the front of the fireplae).
Place the receiver in a location to
the left of the gas control valve
(near the front of the fireplae).
4071126
59
Remove and discard this molex
connector attached to the
blower wiring harness.
Connect the receiver to the
molex connector on the wiring
harness.
100-01195_000