Connections; Connecting The Wireless Subwoofer - Samsung HT-X810 User Manual

connections

This section involves various methods of connecting the Digital Home Theater to other external components.
Before moving or installing the product, be sure to turn off the power and disconnect the power cord.

CONNECTING THE WIRELESS SUBWOOFER

Press the POWER button on the rear of the subwoofer to turn it on.
•
If the main unit is turned on
The subwoofer will be automatically connected to the product and
the Link LED on its front will blink blue for a few seconds.
•
If the main unit is turned off
The Link LED on the front of the subwoofer will blink blue for about
30 seconds, then will change to red as the sub switches to
STANDBY mode.
M

If the subwoofer is turned off, you will see S/W CHECK on the display panel of the main unit.

Place the wireless subwoofer under the main unit.

If you use a device such as a microwave oven, wireless LAN Card, Bluetooth equipment, or any other
device that uses the same frequency (5.8GHz) near the system, some sound interruption may be
heard due to interference.

The transmission distance of radio wave is about 32 feet, 9.7 inches, but may vary depending on
your operating environment. If a steel-concrete wall or metallic wall is between the main unit and the
wireless subwoofer, the system may not operate at all, because the radio wave cannot penetrate
metal.

If the main unit doesn't make wireless connection, the system needs ID Setting between the main
unit and wireless subwoofer. With the main unit turned off, press the remote control's
"0"J"1"J"3"J"5" number buttons and the unit will turn on. With the wireless subwoofer turned on,
press ID SET button on the back of the unit for 5 seconds.

The wireless receiving antenna is built into the wireless subwoofer. Keep the unit away from water and
moisture.

For optimal listening performance, make sure that the area around the wireless subwoofer location is clear
of any obstructions.
ID SET button POWER button
17