System Layout 1 - Viessmann Vitodens 200-W Series Installation Instructions Manual

Boiler Connections
Installation Examples

System layout 1

Vitodens 200-W, WB2B with a direct-connected heating circuit
L
G
TPV
H
5
Fig. 23
Legend
PRV Pressure relief valve
TPV Temperature and pressure relief valve
Vitodens 200-W WB2B boiler with
Vitotronic 200, HO1 outdoor reset
control
Outdoor temperature sensor
Remote control Vitotrol 300 (optional)
Heating circuit
Heating circuit pump sÖ*
DHW circulating pump sA*
DHW storage tank
DHW tank temperature sensor
I Expansion tank
Flow check valve
J
DHW recirculation pump sK*
Power/Pump module
M Optional purge tee (field supplied)
* See pages 54 and 58.
30
(continued)
A
PRV
M
K
F
Installation of ...
H radiator heating circuit (high-temp. circuit)
H DHW production
... with the following flow conditions:
The flow rate of the heating circuit is less
than the maximum possible water flow rate
of the Vitodens 200-W WB2B boiler (see
page 26 for maximum water flow rate of
boiler).
The use of a low-loss header is strongly
recommended if the maximum water flow
rate in the application concerned exceeds
the values shown in the applicable table on
page 29, or if the system flow rates are
unknown.
The low-loss header is available as
accessory part.
See following pages for installation
examples with a low-loss header.
B
1
C
J
I
D
E
IMPORTANT
Please note location of expansion tank I
and flow check valve J .
IMPORTANT
DHW circulating pump must pump into
the Vitodens 200-W boiler (as illustrated).