EverFocus ECOR 264x1-16 Instruction Manual page 45

IP Address
Subnet Mask
Gateway
DNS server 1
DNS server 2
Apply
Note: If parameters in EXPESS menu are entered, the changed parameters can be verified in the
related SETUP menus (e.g. menu CAMERA).
If EXPRESS menu is closed and re-opened again, the menu will not show the canges, it will show
always factory settings!
This field shows the current IP Address for the DVR. If Fixed IP address is
used then this value must be set manually. If DHCP or PPPoE is selected, this
value will be assigned automatically.
This field shows the subnet mask for your network so the DVR will be
recognized within the network. If DHCP or PPPoE is selected, this value will be
assigned automatically.
This field shows the gateway for your network so the DVR will be able to
communicate outside the network. If DHCP or PPPoE is selected, this value
will be assigned automatically.
This field shows the primary DNS server for your network. When DHCP is
selected and an internet connection is available, this value will be assigned
automatically. This field must be assigned correctly if you plan to use the
DDNS feature (see Section DDNS for more details).
This field shows the secondary DNS server for your network.
Press "Apply" button to save and apply the Express settings to DVR. The
system will automatically adjust recording frame rate according to your
settings. The following message will pop up;
press "Yes" to change Resolution, Recording frame rate and Quality depending
on your Express settings.
39