Binatone Speakeasy Combo 3410 User Manual page 26

4. Press the Down to select a base number (BASE 1, 2,3 or 4)
5. Press the MENU/OK to see
OK
(Key in the 4 digit PIN code for the base - the SC3410 default PIN code is 0000.
6. Press the MENU/OK to confirm, and the display will flash
OK
"SEARCHING 1" (or 2,3,4)
7. At the same time, on the base, press the MENU/OK to see "PHONEBOOK"
OK
8. Press the UP tweice to see "REGISTRATION"
9. Press the MENU/OK to see "SEARCHING" will flash on base display
OK
After a short delay, if the registration is successful, there will be a confirmation
beep, and the Handset display will go back to idle mode with the new handset
To S etup a three-way conference
snumber shown (e.g. HS1, HS2). The base display will also go back to idle mode.
To select a base
The handset can be registered to more than one base (up to a maximum of 4), and
you can select which base you want the handset to operate with.
If you select "AUTO" the handset will link with the first of the registered bases
that it finds.
1. Press the MENU/OK to see "PHONEBOOK"
OK
2. Press the DOWN 3 times to see "HS SETTINGS"
3. Press the MENU/OK to see "ALARM"
OK
4. Press the DOWN 8 time to see "SELECT BASE"
5. Press the MENU/OK to confirm, and the display shows
OK
the present linked base number, e.g "BASE 1 +"
6. Press UP or DOWN to select which base you want the handset to
link with (BASE 1,2,3,4 or AUTO).
Note: the handset will only link with base numbers followed by a "+".
7. Press MENU/OK to confirm the base.
OK
The display will show "SEARCHING 1" (or 2,3,4) and there will be a
short delay until the handset finds the base and the display returns to idle.
*
Press PHONEBOOK/BACK
Binatone Help Line : 0845 345 9677
"PIN ?"
to go back to idle mode at any time.
24