Maintenance - Napoleon EF30 Installation And Operating Instructions Manual

16

7.0 MAINTENANCE

ALWAYS DISCONNECT THE POWER AND ALLOW THE ELECTRIC APPLIANCE TO COOL BEFORE
PERFORMING ANY CLEANING, MAINTENANCE OR RELOCATION OF THIS ELECTRIC APPLIANCE.
TURN CONTROLS TO OFF AND REMOVE PLUG FROM OUTLET OR TURN OFF THE HOUSE CIRCUIT
DO NOT INSTALL REPLACEMENT BULBS THAT EXCEED SPECIFIED MAXIMUM WATTS.
THE HALOGEN LIGHT BULBS IN YOUR UNIT CAN BECOME EXTREMELY HOT. ALLOW AT LEAST 10
MINUTES BETWEEN TURNING OFF THE APPLIANCE AND REMOVING THE LIGHT BULBS TO AVOID
ACCIDENTAL BURNS. DO NOT HANDLE THE LAMP (BULBS) WITH BARE FINGERS, OILS FROM
YOUR SKIN WILL DAMAGE THE BULBS WHEY THEY HEAT UP. USE GLOVES OR A CLEAN DRY
Most halogen lamps are rated to last approximately 1800 hours. Like all lamps, halogen lamps require periodic
replacement. When the lamps in your appliance have burned out, you will notice one or more of following:
COMMON OBSERVED PROBLEMS:
- There is no fl ame
- Flame or Ember bed is dim or dark in certain areas
- Flame is not moving or glowing
Your appliance must be opened in order to replace the lamp. To reduce the number
of times you need to open the appliance, replace all lamps at the same time if they
are close to the end of their rated life.
There are a total of 8 halogen lamps (Type G6.35, rated 120Volts, 35Watts)
supplied with your appliance:
- 2 lamps provide illumination for the ember bed
- 2 lamps provide illumination for fl ame generation
- 4 extra lamps for replacement
W415-0675 / D / 12.14.11
WARNING
!
BREAKER TO ELECTRIC APPLIANCE RECEPTACLE.
CLOTH WHEN HANDLING BULBS.
LAMP TYPE:
G 6.35, 120V, 35W
Maximum
8 pcs included