Table of Contents
Advertisement
SAFETY PRECAUTIONS
• Never carry the tool or put it down while the wheel is rotating. Make sure it is completely stopped before moving your
position or set the tool down.
• Do not operate the tool with the wheel guard removed.
• Keep the handles dry, clean and free of oil at all times.
• Operate the tool in well ventilated areas only.
• Do not operate the tool if the wheel does not stop when the trigger is released.
• Inspect the wheel guard and collars for damage after any wheel breakage on the tool.
• Always use full throttle when cutting.
• Never cock, jam or wedge the wheel during the cut. Do not use the side of the wheen as a cutting surface.
• Make sure the tool is designed for the wheel direction suitable for the job. Do not reverse the direction of the wheel rota-
tion by changing the direction of the oil fl ow.
• Always operate the tool within its rated capacity. Never exceed the maximum operating speed marked on the wheel.
• Do not operate the tool near fl ammable materials.
• Do not over-reach.
• Do not use the tool for applications for which it was not designed.
• Keep the wheel off all surfaces when starting the saw.
• Do not attempt to adjust the fl ow control on the valve handle.
• Know the location of burried or covered services before starting work.
• Adjust the wheel guard so it is between you and the cutting wheel.
• Never operate the tool when you are tired.
CUT-OFF WHEEL SAFETY
• Always inspect the cut-off wheels for possible damage before operating the tool. do not use a wheel that is cracked or
otherwise damaged.
• Never transport or store the tool with the cut-off wheel mounted on the saw.
• If the cut-off saw is dropped with a cutting wheel installed, thoroughly examine the cutting wheel before use.
• Make sure the cutting wheel is correctly mounted and tightened before use.
• Operate the cut-off saw at no load for 30 seconds in a safe position. If considerable vibration or other defects are
detected, stop operation of the tool immediately and determine the cause. Do not use the tool until the defect is corrected.
• Only use cutting wheels that comply with ANSI B7.5/ISO 525, 603.
• Check that the maximum operating speed of the cutting wheel is equal to or greater than the rated shaft speed of the
cut-off saw. Wheels must be rated at 4500 rpm minimum.
7
Advertisement
Table of Contents
