Peavey MediaMatrix NION Hardware Manual page 44

Chapter 5 - Setting up the NION
8. Type
9. Type
The parameter <filename> is either a single file or a wildcard referencing multiple files.
When you have finished copying files, type
Managing users
Introduction
Users are created via the web interface, and assigned privileges to allow them to perform
certain operations, as listed below.
Privilege
Deploy
Update Firmware
Debug Menu Access
User Administration
NioNode Administration
Access
Log Access
There are two default users: superuser and defaultuser, which cannot be deleted. You can
add your own users as necessary.
superuser
defaultuser
In NWare, when you perform an action that involves the node, such as deploying a role or
updating firmware, NWare logs on to the node using a particular username. The node matches
this username with the username of the same name stored on the unit. The privileges of the
username on the node determine whether the action may be carried out.
Tip: Users often log on to nodes with the username defaultuser. If the settings for this
username on the node show the Deploy privilege set to Disallow, it will not be possible to
deploy a role to the node even when they are logged on.
40
to switch to binary copy mode.
binary
and press Enter.
mput <filename>
Version 1.6.1.0
to close the ftp session.
quit
What it controls
Determines whether the user can deploy a role to this node.
Determines whether the user can update the firmware on this
node.
Determines whether the user can access the debug menu of
this node using the Pandebug application.
Determines whether the user can create, edit and remove user
accounts on this node.
Determines whether the user can change settings such as
network configuration and time and date.
Determines whether the user can view or clear the log.
Tip: For more information on viewing the log within NWare,
see Remote Log in the NWare User Guide.
Has all privileges enabled. None of its settings can be
changed, apart from the password, which is blank by default.
Has all privileges enabled, apart from User Administration
and NioNode Administration Access.
September 30, 2010